I'm looking for a carbine-length railed handguard to replace the tubular aluminum forend on my LR-308. All the free-float units appear to be around the same cost, give or take. The DPMS quad-rail is $180 and the couple aftermarket units I've seen tend to go up from there.
Does anyone have experience with Troy Industries parts? I'm looking at the Troy BattleRail TRX-308 7.2″ http://troyind.com/%20/rail-systemsacce ... rx-308-7-2. I want solid and worth the effort of mounting this to my gun.
Any recommendations? Thanks.
Troy Industries handguards: Any impressions?
-
UnderwaterMike
- Sharp Shooter
- Posts: 228
- Joined: Tue, 24 Mar 2009 17:45:19
- Location: Chantilly
Troy Industries handguards: Any impressions?
Proudly American by birth. Proudly Virginian by choice.
-
jrswanson1
- Sharp Shooter
- Posts: 752
- Joined: Tue, 17 Aug 2010 09:23:03
- Location: Woodbridge
Re: Troy Industries handguards: Any impressions?
I have a Troy rail on one of my ARs, it's a solid bit of kit. Troy makes good stuff.
-
gunderwood
- VGOF Platinum Supporter
- Posts: 7189
- Joined: Sat, 19 Dec 2009 00:28:34
Re: Troy Industries handguards: Any impressions?
I don't have the rail in question, but I do have other Troy products and they are solid. I have seen that rail on an AR15 though and it was nice.
sudo modprobe commonsense
FATAL: Module commonsense not found.
FATAL: Module commonsense not found.