Looking for a weekend gun project?

[OakRidgeStars]

Want something to shut up that annoying guy at the range with the Ma-Deuce? This should do it*

http://www.apexgunparts.com/gsh-23-cannon.html

*some assembly required.

[SHMIV]

Want something to shut up that annoying guy at the range with the Ma-Deuce? This should do it*

<!-- m --><a class="postlink" href="http://www.apexgunparts.com/gsh-23-cann ... ml</a><!-- m -->

*some assembly required.

Yep. Want.

I've been looking for the perfect hood ornament for my truck. That'll do it. Just have to figure out where in the cab to put the trigger.

[ Post made via Mobile Device ]

[jdonovan]

by getting a pile of metal parts?

torch cut receiver, and torch cut barrels, does not make for a good starting point for a cannon.

Now this:
http://www.sturmgewehr.com/forums/index ... omment-892

is much more usable, 'eh costs a bit more, but is ready to roll, straight away.

so so very tempting.

[AlanM]

I once caught up with two semis each pulling lowboy trailers with two 5"/38 single barrel gun mounts.
One with its barrel raised and pointing over the top of the cab of the tractor and the other had its barrel depressed and pointing straight back.



You DO NOT tailgate for long when you are staring up at a 5" gun barrel pointed right at you (rain plugged or not).

It was on a two lane section of US 10 in Montana and it took a while to find a safe place to pass them.
As for when this happened: I was driving my new, not out of warranty, 1970 Opel GT.

[OakRidgeStars]

by getting a pile of metal parts?

torch cut receiver, and torch cut barrels, does not make for a good starting point for a cannon.

It could be dun...