Page 1 of 1
Lower reciever engraving
Posted: Mon, 15 Aug 2011 21:31:20
by sbr4141
Need to get my lower engraved with my NFA trust name. Anyone have any recomendations in the Richmond area?
Re: Lower reciever engraving
Posted: Mon, 15 Aug 2011 23:32:47
by Jakeiscrazy
sbr4141 wrote:Need to get my lower engraved with my NFA trust name. Anyone have any recomendations in the Richmond area?
I heard some of the Things Remembered will do it. But apparently it varies some will some won't. Can't hurt to try. Also a local trophy shop may do it.
Re: Lower reciever engraving
Posted: Tue, 16 Aug 2011 16:35:55
by jdonovan
go up and see Mike at TSC machine.
He is up next to Kings Dominion.
Re: Lower reciever engraving
Posted: Wed, 17 Aug 2011 01:29:30
by Diomed
Jakeiscrazy wrote:I heard some of the Things Remembered will do it. But apparently it varies some will some won't. Can't hurt to try. Also a local trophy shop may do it.
Again, if you go with one of the mall shops, make sure they can actually meet the depth requirement. That means displacing metal. Not a lot, but more than the usual engraving laser can do (which is none at all).
Re: Lower reciever engraving
Posted: Tue, 23 Aug 2011 22:48:46
by ArsenalAttorneys
I met JJ Roberts at the Nation's Gun Show, and I'm sure he can engrave your receiver. His website is
http://www.angelfire.com/va2/engraver/.
There's also Thierry Duguet in Charlottesville
http://www.engraver.net/
I would be very careful about the typical trophy shop or engraver at the mall. They use modern equipment that often lacks the strength and quality to provide precise engraving that is deep enough to take wear and tear.
I've sent clients to Roberts who have come to me for NFA gun trusts
http://www.arsenalattorneys.com