Virginia Gun Owners Forum - VGOF

Posted: **Sat, 16 May 2009 14:24:56**

I got the following email from a customer and wondering if anyone can help out.

Hi Rick,
I ordered this stock for my Maverick 88. I did not see any instructions so I went online to the ATI website and found some almost instructions. My problem is that the hex bolt holding the existing pistol grip onto the shot gun is only 1.5 inches long. I can not seem to get anything to fit together. I was assuming that I connect it through the butt after I remove the butt plate but even then the bolt is too short. Any ideas?

Here is the stock in question:
Shotgun Buttstock/Pistol Grip fits 12/20 gauge Maverick 88, Remington 870, Mossberg 500/535/590/835 and Winchester 1200/1300

Posted: **Sat, 16 May 2009 14:29:51**

hmm..I found installation instructions at the ATI website. Maybe that will help.

http://www.atigunstocks.com/documents/i ... ctions.pdf

After reading these instructions a little more, it looks like he needs to only use the single small spacer required for the Maverick 88.

Posted: **Sat, 16 May 2009 15:33:16**

Yep, that's the same thing I had to do to mount the ATI stock on my Mossberg 500.

Posted: **Sat, 16 May 2009 15:36:39**

I think this problem has been resolved. This particular Maverick 88 had been modified previously with a pistol grip. The original bolt from the original stock was apparently thrown away and replaced with the bolt that came with the pistol grip. So, this guy is going to Lowes to get a longer bolt and the problem should be corrected.

Posted: **Sat, 16 May 2009 15:50:47**

I've seen parts like this for sale on Ebay for cheap, usually as a take-off item.

Posted: **Sat, 16 May 2009 21:12:29**

allingeneral wrote:I think this problem has been resolved. This particular Maverick 88 had been modified previously with a pistol grip. The original bolt from the original stock was apparently thrown away and replaced with the bolt that came with the pistol grip. So, this guy is going to Lowes to get a longer bolt and the problem should be corrected.

Exactly...pistol grip bolt is shorter than OEM bolt. ATI requires OEM bolt to be used.

Posted: **Sat, 16 May 2009 22:27:15**

Here's how his Maverick 88 turned out with the pistol grip stock after a visit to Lowes for a 3-inch 5/16-18 Socket Head Cap Screw

[attachment=0]Maverick-88-2.jpg[/attachment]

Posted: **Sun, 17 May 2009 07:19:25**

Nice

Virginia Gun Owners Forum - VGOF

Replacing the stock on a Maverick 88

Replacing the stock on a Maverick 88

Re: Replacing the stock on a Maverick 88

Re: Replacing the stock on a Maverick 88

Re: Replacing the stock on a Maverick 88

Re: Replacing the stock on a Maverick 88

Re: Replacing the stock on a Maverick 88

Re: Replacing the stock on a Maverick 88

Re: Replacing the stock on a Maverick 88