Virginia Gun Owners Forum - VGOF

I know, weird.

What I'm trying to do it get the outline (preferably a trace, then scan of that trace) Of some Hybrid IWB holsters. Crossbreed, MaxTuck, etc. I'm going to attempt some DIY IWB's and looking for starting points, then I'm going to attempt to tweak them to make them better (better for me at least). I wear at 3:00 and most if the IWB's are the most comfortable at 4:00-5:00. So the plan is, to essentially start with say a CBST ripoff made with very cheap leather, and some (maybe) carbon paper, use the carbon paper to mark pressure points and IF it works do some custom cutting and wind up with a custom fit holster. If successful I'd trace the prototype out and re-cut with a quality leather. Yes, I'm bored. But if somebody could help me out it would be appreciated.

I'm useless here, but cool idea. Let us know how it turns out.

[ Post made via Mobile Device ]

Here's a link to a pdf of my Foxx Hybrid for my SCCY CPX-2. It prints actual size. Hope it helps.

http://www.pdf-archive.com/2013/07/25/foxx-hybid-scan/

Stratojaxter wrote:Here's a link to a pdf of my Foxx Hybrid for my SCCY CPX-2. It prints actual size. Hope it helps.

http://www.pdf-archive.com/2013/07/25/foxx-hybid-scan/

Thanks man, That will help a lot, that's a good shape too!

I would lean toward mimicking the Comp Tac holsters, you can adjust the cant, the tension, swap out kydex molds for different firearms, and interchange belt loops, IMO its the best commercially made holster.