Walther PPK and PPK/S Safety Recall
- allingeneral
- Site Admin

- Posts: 9678
- Joined: Sun, 01 Mar 2009 17:38:25
- Location: King George, Virginia
- Contact:
Walther PPK and PPK/S Safety Recall
I read about this in American Rifleman and felt the need to pass it on.
Walther PPK and PPK/S pistols - RECALL
DESCRIPTION OF THE HAZARD:
Smith & Wesson has identified a condition that may exist in certain PPK and PPK/S pistols which may permit a round to be discharged without the trigger being pulled. When the manual safety is disengaged, Smith & Wessons Product Engineering Group has determined that the possibility exists in certain firearms that lowering the hammer may cause a chambered round to fire.
DESCRIPTION OF THE PRODUCT INVOLVED:
This recall applies to all Walther PPK and PPK/S pistols manufactured by Smith & Wesson from March 21, 2002, until February 3, 2009. The Serial Numbers of the pistol subject to this recall are as follows:
0010BAB - 9999BAB
0000BAC - 9999BAC
0000BAD - 9999BAD
0000BAE - 9999BAE
0000BAF - 9999BAF
0000BAH - 9999BAH
0000BAJ - 9999BAJ
0000BAK - 9999BAK
0000BAL - 5313BAL
0000BAM - 1320BAM
0000LTD - 0499LTD
0001PPK - 1500PPK
0026REP - 0219REP
0001WLE - 0459WLE
REMEDY/ACTION TO BE TAKEN:
STOP USING YOUR PISTOL AND RETURN IT TO SMITH & WESSON AT ONCE.
Any unintended discharge of a firearm has the potential for causing injury, and we ask that you stop using your pistol immediately.
To facilitate the repair of your pistol, please contact Smith & Wesson's customer service department to receive instructions for the return of your pistol to Smith & Wesson.
When you return your pistol to Smith & Wesson, we will replace the existing hammer block feature with a new part at no cost to you. Your firearm will be returned as quickly and efficiently as possible.
VERIFICATION OF CORRECTIVE ACTION:
When your pistol is returned, you should note a punch dot which appears at the back of the frame. This marking is verification that the new hammer block has been installed and that your pistol is safe to handle.
CONSUMER CONTACT:
To receive a FedEx pre-paid billable stamp and shipping instructions to arrange for the modification of your pistol click here or contact Smith & Wesson directly at 1-800-331-0852. Please allow 2-3 weeks to receive the information packet from us.
IF YOU HAVE ANY QUESTIONS ABOUT THIS RECALL, PLEASE CONTACT SMITH & WESSON AT
1-800-331-0852 or email us at PPK_S@smith-wesson.com.
View the full recall information at http://www.smith-wesson.com/ppksafety
Walther PPK and PPK/S pistols - RECALL
DESCRIPTION OF THE HAZARD:
Smith & Wesson has identified a condition that may exist in certain PPK and PPK/S pistols which may permit a round to be discharged without the trigger being pulled. When the manual safety is disengaged, Smith & Wessons Product Engineering Group has determined that the possibility exists in certain firearms that lowering the hammer may cause a chambered round to fire.
DESCRIPTION OF THE PRODUCT INVOLVED:
This recall applies to all Walther PPK and PPK/S pistols manufactured by Smith & Wesson from March 21, 2002, until February 3, 2009. The Serial Numbers of the pistol subject to this recall are as follows:
0010BAB - 9999BAB
0000BAC - 9999BAC
0000BAD - 9999BAD
0000BAE - 9999BAE
0000BAF - 9999BAF
0000BAH - 9999BAH
0000BAJ - 9999BAJ
0000BAK - 9999BAK
0000BAL - 5313BAL
0000BAM - 1320BAM
0000LTD - 0499LTD
0001PPK - 1500PPK
0026REP - 0219REP
0001WLE - 0459WLE
REMEDY/ACTION TO BE TAKEN:
STOP USING YOUR PISTOL AND RETURN IT TO SMITH & WESSON AT ONCE.
Any unintended discharge of a firearm has the potential for causing injury, and we ask that you stop using your pistol immediately.
To facilitate the repair of your pistol, please contact Smith & Wesson's customer service department to receive instructions for the return of your pistol to Smith & Wesson.
When you return your pistol to Smith & Wesson, we will replace the existing hammer block feature with a new part at no cost to you. Your firearm will be returned as quickly and efficiently as possible.
VERIFICATION OF CORRECTIVE ACTION:
When your pistol is returned, you should note a punch dot which appears at the back of the frame. This marking is verification that the new hammer block has been installed and that your pistol is safe to handle.
CONSUMER CONTACT:
To receive a FedEx pre-paid billable stamp and shipping instructions to arrange for the modification of your pistol click here or contact Smith & Wesson directly at 1-800-331-0852. Please allow 2-3 weeks to receive the information packet from us.
IF YOU HAVE ANY QUESTIONS ABOUT THIS RECALL, PLEASE CONTACT SMITH & WESSON AT
1-800-331-0852 or email us at PPK_S@smith-wesson.com.
View the full recall information at http://www.smith-wesson.com/ppksafety
- zephyp
- VGOF Platinum Supporter

- Posts: 10207
- Joined: Tue, 05 May 2009 08:40:55
- Location: Springfield, VA
Re: Walther PPK and PPK/S Safety Recall
I cant resist -- nah, I wont... 
No more catchy slogans for me...I am simply fed up...4...four...4...2+2...


-
SgtBill
- VGOF Silver Supporter

- Posts: 1626
- Joined: Tue, 02 Jun 2009 09:31:47
- Location: Charlotte County Va.
Re: Walther PPK and PPK/S Safety Recall
I had one a PPK/S that was on the recall list. I did the contact thing and had the gun repaired in less then 2 week's. A good job on S&W's part, but they should have sold the damn thing witout any problems attached.
P.S. I traded mine in on a Walther PK-380
Bill
P.S. I traded mine in on a Walther PK-380
Bill
- zephyp
- VGOF Platinum Supporter

- Posts: 10207
- Joined: Tue, 05 May 2009 08:40:55
- Location: Springfield, VA
Re: Walther PPK and PPK/S Safety Recall
Bill are you sure it was a PPK and not a PPK/S and did the clips get recalled too... 
No more catchy slogans for me...I am simply fed up...4...four...4...2+2...


-
OakRidgeStars
- VGOF Gold Supporter

- Posts: 14108
- Joined: Sun, 22 Mar 2009 10:13:20
Re: Walther PPK and PPK/S Safety Recall
Uh oh....zephyp wrote:Bill are you sure it was a PPK and not a PPK/S and did the clips get recalled too...

- Hiwaytahell
- VGOF Silver Supporter

- Posts: 730
- Joined: Mon, 20 Apr 2009 15:35:12
- Location: Alexandria
-
OakRidgeStars
- VGOF Gold Supporter

- Posts: 14108
- Joined: Sun, 22 Mar 2009 10:13:20
Re: Walther PPK and PPK/S Safety Recall
Al Gore wasn't very busy last night, so Rick had him reinvent it

Re: Walther PPK and PPK/S Safety Recall
You guys are like comedy central! 
Now is the time for all good men to get off their rusty dustys...
- allingeneral
- Site Admin

- Posts: 9678
- Joined: Sun, 01 Mar 2009 17:38:25
- Location: King George, Virginia
- Contact:
Re: Walther PPK and PPK/S Safety Recall
Well - to give the guy a break with the PPK vs. PPK/S issue... It seems that there are some PPK pistols that are stainless and some PPK/S that are not. So, just having a stainless slide doesn't make it a PPK/S.
Reference: http://www.waltherpistols.com/category/ ... dguns.aspx
So, what's the real difference between the PPK and PPK/S?
http://www.differencebetween.net/object ... -and-ppks/
Reference: http://www.waltherpistols.com/category/ ... dguns.aspx
So, what's the real difference between the PPK and PPK/S?
http://www.differencebetween.net/object ... -and-ppks/
Re: Walther PPK and PPK/S Safety Recall
One has a "clip", and the other has a "magazine"!allingeneral wrote:So, what's the real difference between the PPK and PPK/S?
Engage your brain!
- zephyp
- VGOF Platinum Supporter

- Posts: 10207
- Joined: Tue, 05 May 2009 08:40:55
- Location: Springfield, VA
Re: Walther PPK and PPK/S Safety Recall
I'm confused...do bullets go in a clip or magazineYarddawg wrote:One has a "clip", and the other has a "magazine"!allingeneral wrote:So, what's the real difference between the PPK and PPK/S?
No more catchy slogans for me...I am simply fed up...4...four...4...2+2...


-
SgtBill
- VGOF Silver Supporter

- Posts: 1626
- Joined: Tue, 02 Jun 2009 09:31:47
- Location: Charlotte County Va.
Re: Walther PPK and PPK/S Safety Recall
I am so confused. Thank God for a voice of pure knowledge (Rick's).
LOL Bill
LOL Bill
- allingeneral
- Site Admin

- Posts: 9678
- Joined: Sun, 01 Mar 2009 17:38:25
- Location: King George, Virginia
- Contact:
Re: Walther PPK and PPK/S Safety Recall
*grumble* *snicker*SgtBill wrote:I am so confused. Thank God for a voice of pure knowledge (Rick's).
LOL Bill
Bill, this might be the first sentence where I've seen you use an apostrophe correctly!
-
SgtBill
- VGOF Silver Supporter

- Posts: 1626
- Joined: Tue, 02 Jun 2009 09:31:47
- Location: Charlotte County Va.
Re: Walther PPK and PPK/S Safety Recall
Never said I was any good at putting poop on paper or computers but most people can get the idea of what I am trying to say.
Bill
Bill

